Views: 1 Author: Site Editor Publish Time: 2026-11-20 Origin: Site
Jiehuan supplies hook and loop tape in three grades: A, B and C. The figures below are the contractual minimums taken from our controlled specification sheets (serial NF_PZ_003). They are guaranteed values rather than laboratory bests, so a delivered lot should meet or exceed them.
Property | Grade A | Grade B | Grade C |
|---|---|---|---|
Hook base material | Nylon 6 | Polyester | Polyester |
Hook density (pcs/in²) | 310 | 295 | 195 |
Loop thickness (mm) | 2.5–2.8 | 2.1–2.3 | 1.5–2.0 |
Peel strength (N/cm) | ≥2.0 (Enhanced) | ≥1.6 | ≥1.6 |
Shear strength (N/cm²) | ≥11.0 | ≥7.5 | ≥7.5 |
Slit width | Grade A and B | Grade C |
|---|---|---|
Under 60 mm | ±1 mm | −1 / +2 mm |
60–100 mm | −1 / +2 mm | ±2 mm |
Over 100 mm | ±2 mm | ±2 mm |
Grade A Enhanced is validated to 5,000 open-close cycles, retaining ≥6.0 N/cm² in shear and ≥1.2 N/cm in peel after cycling. Grade C is tested to 1,000 cycles. Cycle data for a specific grade and load case is available on request — it is not interchangeable between grades, because hook geometry and loop density differ.
Peel and shear are separate measurements and must not be compared with each other. Peel governs how easily a closure opens; shear governs how much sliding load the joint carries before it moves. A tape can be strong in shear and still open easily — for most closures that is the combination you want, and it is why the two figures are always quoted side by side.
Our grade names (A, B and C) are internal product tiers. They do not map one-to-one onto the classes in GB/T 23315-2026. If you need a written grade-to-standard mapping for a tender, a drawing or an incoming inspection plan, ask us and we will supply it. Jiehuan is a drafting member of GB/T 23315-2026.
These sheets cover the tape itself. Adhesive coating, PUR lamination, heat sealing and die-cutting are processes applied to the tape afterwards, so they are quoted separately with their own parameters rather than folded into the grade table.
Download the three-grade TDS with MSDS data from our download page, or ask for a sample matched to your load case. Tell us the substrate, the cycle count and the peel direction and we will recommend a grade instead of a range.
Grade A, B and C tape performance is published in full: see peel, shear and thickness data.
